TrackBack: http://www.best-laptop-battery.co.uk/blog/2009/02/19/secondary-development-of-fuel-cell-engine-control-system-design-and-implementationc/
Controller port upgrade dell laptop battery
Controller in the hardware set up a lot of control port, for example, analog-digital conversion modules to connect a variety of A / D sampling ports, digital-analog conversion module’s D / A port at the same time a number of fan control, I / O module through the I / O port to control the opening and closing of relays, as well as hydrogen to receive alarm information, which connect to the controller hardware port can be configured to carry out soft-upgrade. When the fuel cell engine control system for the various subsystems or stack testing rectification, some lines with the controller port dell latitude d820 battery connection can not help but want to change, then, through the terminal on the PC configuration can easily adjust the controller’s internal interface settings, so that the controller quickly adapt to the new hardware requirements.
As shown in Figure 3, A / D sampling signal are the dell inspiron e1505 battery main input channels, such as hydrogen signal acquisition and out of reactor pressure, reactor voltage electric current, air current, and out of reactor temperature, cooling water and the water level in humidifier water flow, etc.; I / O port DSP figure mainly refers to the volume of import and export, through the control relay output to control a variety of solenoid valves, pumps, electrical switches, such as charging the load switch, hydrogen nitrogen tail valves, pumps and humidification of hydrogen circulating pump and so on; I / O input includes a number of hydrogen alarm switch signal; digital-analog conversion module will be DSP digital output into analog control fan, each D / A control of a fan, the size of output decision the processing speed of the fan speed. When the hardware port because dell td347, dell inspiron 2600 battery electric shift reactor, circuit changes and reorganization, the adoption of end-to-PC ports can be reconfigured to enable control system in the case of free programming with the new hardware requirements to keep updated.
